My HORIZON MC-80 tower no longer starts or stops. What could that be?

That could be due to sensors.

The machine can no longer recognize the start / stop position. This position is based on the shaft that moves the suction rods.

The corresponding sensors are called B11 and B12 and in this case would have to be ordered from Horizon and exchanged.

For questions do not hesitate to contact us.

Here you can check all our available collators.

Can the HORIZON VAC-100 tower also deliver to the right?

The VAC-100c tower can do that.

VAC-100a or VAC-100m cannot do that.

In addition, a special jogger is needed for right-side delivery – this is the HORIZON PJ-77R.

You can find all our joggers here and our collators here.

You can also check our YouTube Channel.

I have some trouble with my HORIZON BQ-160. If the book block runs over the router, the milling wheel does not turn. What could that be?

It could be the engine. In this case, you can obtain a motor as a spare part from Horizon GmbH.

But it’s also possible that it is on the upstream contactor, which no longer switches through all 3 phases and thus stops the milling machine. That would be the smaller effort.

For more questions contact us.

You can check all available binders here.

I want to expand my Horizon system. Do the towers you offer fit my existing HORIZON system?

Please give us the serial number of the system and the number that is on the EPROMs of the main board.

Then we can see which extension tower suits your system.

You can see all our available HORIZON towers here.

In general, brochure production from Horizon can be expanded to up to 6 towers.

What can I do if there are no spare parts for my HORIZON machine?

In our warehouse we also have machines that we only use as spare parts stores. From this inventory we can supply spare parts that are otherwise no longer available.

Normally, however, the spare parts must be purchased from Horizon GmbH / Quickborn (for Germany).

Let us know which part you need!